June 2019
Application of the TheRmophoretic Annular Precipitator (TRAP) for the study of soot aggregates morphological influence on their thermophoretic behaviour
Ait Ali Yahia L., Géhin E., Sagot B. (2017). Application of the TheRmophoretic Annular Precipitator (TRAP) for the study of soot aggregates morphological influence on their thermophoretic behaviour. Journal of Aerosol Science. Volume 113, pp 40-51. (IF [...]
Quantification according to the particles diameter
Pellerin G., Maro D., Damay P.,Géhin E., Connan O., Laguionie P., Heberta D., Solier L., Boulaud D., Lamaud E., Charriere X.(2017), : Quantification according to the particles diameter, Journal of Aerosol Science, Volume 114, [...]
Spectral band decomposition combined with nonlinear models
Ouaret R., Ionescu A., Petrehus V., Candau Y., Ramalho O. (2018), Spectral band decomposition combined with nonlinear models: application to indoor formaldehyde concentration forecasting, Stochastic Environmental Research and Risk Assessment, Vol. 4, pp 985-997, DOI [...]
Experimental validation of the TRAP
Ait Ali Yahia L., Géhin E., Sagot B. (2017), Experimental validation of the TRAP (TheRmophoretic AnnularPrecipitator) in laminar configuration.Journal of Aerosol Science Volume 109, July 2017, pp 38-54. (IF 2016: 2,042)
Aerosol particle dry deposition velocity above natural surfaces
Pellerin G., Maro D., Damay P.,Géhin E., Connan O., Laguionie P., Heberta D., Solier L., Boulaud D., Lamaud E., Charriere X.(2017) Aerosol particle dry deposition velocity above natural surfaces: Quantification according to the particles diameter [...]
July 2018
Benchmark de méthodes d’identification de paramètres sur données simulées : application à la mesure sur site de la résistance thermique de parois de bâtiments en utilisant la thermographie infrarouge active
Résumé – Ce travail porte sur la réalisation d’un benchmark de méthodes d’identification en vue de mesurer sur site la résistance thermique de parois de bâtiment par thermographie infrarouge active. Les mesures virtuelles sont générées à l’aide de différents Modèles Physiques Générateurs. Plusieurs méthodes d’estimation de paramètres sont comparées. Les résultats présentés se focalisent sur les parois ITI (Isolation Thermique par l’Intérieur) et montrent qu’une estimation satisfaisante de la résistance thermique de la paroi est possible dans de nombreux cas.